Skip to content

Buick Lesabre 2001–2005 Key Fob & Car Keys

Keys that fit the 2001–2005 Buick Lesabre: smart keys and remote keys, 4 buttons, FCC ID K0BLEAR1XT or K0BUT1BT, ID13 or T5 chip, 315 MHz. 4 compatible keys, remotes & shells (genuine and aftermarket) available for the 2001 Buick Lesabre.

Last updated: 15 November 2026

Key specifications for the Buick Lesabre 2001–2005

Key types
smart keys and remote keys
Frequency
315 MHz
Buttons
4-button
Transponder chip
ID13 · T5
Part numbers
25695954
Battery
CR2032
Compatible FCC IDs

To pick the right part, match the part number or FCC ID printed on your original remote, or listed in the Buick parts catalogue, with the specifications on each listing. Every remote listed for the Buick Lesabre 2001–2005 transmits on 315 MHz.

A new smart key or remote has to be programmed to the car with a key programmer, and when every key is lost the programming is still done through the diagnostic port. We ship the key worldwide from the UAE by DHL and FedEx; any automotive locksmith or the dealer can cut and program it.

Programming the Buick Lesabre 2001 key

Key with a blade (regular or flip)

One tool lists this key.

  • OBDSTAR Key Master G3
    • Add key
    • All keys lost
    • Remote
    reads the PIN by OBD

Programming steps

Add key - on the car(US / Canada cars)

Needs: one original programmed key that starts the car, a new key already cut to the car

  1. Insert the original programmed key and start the engine.
  2. Once the engine runs, turn the key OFF and remove it.
  3. No more than 10 seconds after pulling the original key, insert the new key and switch it to ON.
  4. The security light goes out when the new key is learned; this can happen too fast to see the light come on.
  5. On cars without a security light (2004 to 2007 Grand Prix, Bonneville, Impala), leave the key at ON for 10 minutes 45 seconds to be sure it is learned.
  6. For each extra key, repeat all the steps from the start with the original key.
Watch out: The gap between pulling the original key and switching the new key ON must not exceed 10 seconds.
Add key - on the car(US / Canada cars)

Needs: one working key, new key cut to the vehicle

  1. Cut the new key to the vehicle; have one key that already starts it.
  2. Start the engine with the working key, then turn it to LOCK/OFF and remove it.
  3. Within 10 seconds insert the new key and turn it to ON/RUN.
  4. The security light goes off when the key is learned (this can be too fast to notice).
  5. Start the engine with the new key; for each further key repeat from step 2.
Watch out: Adds only; never erases keys. Up to 10 keys.
All keys lost - on the car(US / Canada cars)

Needs: new key cut to the vehicle, 30 minutes

  1. Cut the new key. Have every key the customer keeps; the old keys stop working at the end.
  2. Insert the new key and turn to ON/RUN without cranking; the security light comes on.
  3. Wait about 10 minutes until the security light goes off, then turn to LOCK/OFF.
  4. Repeat ON/RUN, wait 10 minutes, LOCK/OFF two more times (about 30 minutes in all).
  5. After the third cycle turn to ON/RUN: this key is learned and every previously known key is erased.
  6. Learn the remaining keys with the add-key procedure.
Watch out: All previously learned keys are erased. U.S. only: GM's manuals say Canadian owners must use the dealer.

When the key changed

Key with a blade (regular or flip)

  • 1997 - 1999Chip: None (VATS)(US / Canada cars)Resistor pellet in the key blade (VATS / PASS-Key); no transponder.
  • 2000 - 2005This yearChip: ID13Blade: B99(US / Canada cars)PASS-Key III key, PK3 stamped on the blade; Megamos 13 chip.

Check coverage first: support depends on the tool's software version and the exact model. A tool that is not shown here may still cover this car.

Frequently asked questions

Which keys fit the Buick Lesabre 2001–2005?

4 listings fit the Buick Lesabre 2001–2005: smart keys and remote keys, in 4-button versions. Match the part number or FCC ID printed on your original key with the specifications on each listing.

What frequency does the Buick Lesabre 2001–2005 remote use?

Every remote listed for the Buick Lesabre 2001–2005 transmits on 315 MHz.

Which transponder chip does the Buick Lesabre 2001–2005 key use?

The listings for this car carry: ID13 · T5. Check the chip in each listing's specifications.

Which FCC IDs do Buick Lesabre 2001–2005 remotes carry?

The remotes listed for this car carry FCC ID K0BLEAR1XT and K0BUT1BT. Match it with the FCC ID printed on your original remote.

Which tools program a Buick Lesabre 2001–2005 key?

The tool makers' coverage lists name OBDSTAR Key Master G3 for this car; 1 of them lists all keys lost. Check your tool's latest coverage list before the job.