Skip to content

Isuzu I-290 2007–2008 Key Fob & Car Keys

Keys that fit the 2007–2008 Isuzu I-290: remote keys, 3 buttons, FCC ID L2C0007T, 315 MHz. 2 compatible keys, remotes & shells (genuine and aftermarket) available for the 2007 Isuzu I-290.

Last updated: 15 November 2026

Key specifications for the Isuzu I-290 2007–2008

Key types
remote keys
Frequency
315 MHz
Buttons
3-button
Battery
CR2032
Compatible FCC IDs

To pick the right part, match the part number or FCC ID printed on your original remote, or listed in the Isuzu parts catalogue, with the specifications on each listing. Every remote listed for the Isuzu I-290 2007–2008 transmits on 315 MHz.

A new smart key or remote has to be programmed to the car with a key programmer, and when every key is lost the programming is still done through the diagnostic port. We ship the key worldwide from the UAE by DHL and FedEx; any automotive locksmith or the dealer can cut and program it.

Programming the Isuzu I-290 2007 key

Without a tool

The remote is programmed on the car, without a tool.

Programming steps

Program the remote without a tool(US / Canada cars)

Needs: every remote the customer keeps, working ones included, the car key

  1. Close every door and put the key in the ignition.
  2. Press and hold the power UNLOCK switch on the driver's door panel. Keep holding it until step 4.
  3. Quickly turn the ignition ON, OFF, ON, OFF (ON is the position just before START, OFF is where the key comes out).
  4. Let go of the door-panel UNLOCK switch. The locks lock and unlock to confirm programming mode.
  5. On the first remote, hold LOCK and UNLOCK together until the locks cycle again. This can take up to 30 seconds.
  6. Repeat the LOCK + UNLOCK hold on each other remote, working ones included.
  7. Turn the ignition to ON to leave programming mode.
  8. Turn the ignition OFF, take the key out and test every remote.
Watch out: Every remote, working ones included, must be programmed in the same session. If the locks cycle before you let go of the door switch, programming mode did not start: take the key out, open the door and start over. If it keeps happening, the car's system has a fault and the remotes need a professional tool. If the locks never cycle, the key was turned too fast or too slow, the system has a fault, or the car has no factory keyless entry.

When the key changed

Key with a blade (regular or flip)

  • 2007 - 2008This yearChip: None (PassLock)(US / Canada cars)No chip in the key; PassLock sensor sits in the ignition lock.

Check coverage first: support depends on the tool's software version and the exact model. A tool that is not shown here may still cover this car.

Frequently asked questions

Which keys fit the Isuzu I-290 2007–2008?

2 listings fit the Isuzu I-290 2007–2008: remote keys, in 3-button versions. Match the part number or FCC ID printed on your original key with the specifications on each listing.

What frequency does the Isuzu I-290 2007–2008 remote use?

Every remote listed for the Isuzu I-290 2007–2008 transmits on 315 MHz.

Which FCC IDs do Isuzu I-290 2007–2008 remotes carry?

The remotes listed for this car carry FCC ID L2C0007T. Match it with the FCC ID printed on your original remote.

Can the Isuzu I-290 2007–2008 remote be programmed without a tool?

The remote is programmed on the car, without a tool.