Skip to content

Lincoln MKX 2013 Key Fob & Car Keys

Keys that fit the 2013 Lincoln MKX: smart keys, remote keys and transponder keys, 3, 4 or 5 buttons, FCC ID M3N5WY8609, 2010DJ4009 or CWTWB1U793, ID46 (HITAG 2) or ID49 (HITAG Pro) chip, 315 MHz or 433 MHz. 18 compatible keys, remotes & shells (genuine and aftermarket) available for the 2013 Lincoln MKX.

Last updated: 17 November 2026

Key specifications for the Lincoln MKX 2013

Key types
smart keys, remote keys, transponder keys, key shells, emergency blades and key blanks
Frequency
315 MHz and 433 MHz
Buttons
3-, 4- and 5-button
Transponder chip
ID46 (HITAG 2) · ID49 (HITAG Pro) · 4D-63 (40-bit) · 4D-63 (80-bit)
Blade profile
FO38
Part numbers
164-R7015 / 164-R7016
Battery
CR2032

To pick the right part, match the part number or FCC ID printed on your original remote, or listed in the Lincoln parts catalogue, with the specifications on each listing. The frequency depends on the market the car was sold in, so check 315 MHz and 433 MHz against your original before ordering.

A new smart key or remote has to be programmed to the car with a key programmer, and when every key is lost the programming is still done through the diagnostic port. We ship the key worldwide from the UAE by DHL and FedEx; any automotive locksmith or the dealer can cut and program it.

Programming the Lincoln MKX 2013 key

Smart key (push to start)

One tool lists this key.

  • OBDSTAR Key Master G3
    • Add key
    • All keys lost
    • Remote
    no PIN needed

Programming steps

Add key - on the car(US / Canada cars)

Needs: two programmed intelligent access keys inside the car, the new intelligent access key

  1. Switch the car off and keep all doors closed. Put the new key in the pocket inside the center console, buttons facing down.
  2. Press the driver or passenger power door UNLOCK switch three times.
  3. Press and release the brake pedal once.
  4. Press the power door LOCK switch three times.
  5. Press and release the brake pedal once. The START/STOP button light flashes fast: programming mode, two programmed keys detected.
  6. Within one minute, press START/STOP.
  7. Take the key out of the pocket and press UNLOCK on the new key to exit programming mode.
  8. Check the remote by pressing LOCK then UNLOCK (end on UNLOCK), and check that the new key starts the car.
Watch out: Car off, all doors closed before you start and kept closed throughout. Do all steps within 30 seconds of starting; if a step is out of order, stop and wait at least one minute before starting again. With fewer than two programmed keys, the spare must be programmed with a tool. Up to four intelligent access keys can be stored; at four, MAX # OF FOBS LEARNED shows and a tool is needed to erase keys.
Add key - on the car(US / Canada cars)

Needs: two working Intelligent Access keys, new Intelligent Access key

  1. Switch the vehicle off, close all doors and keep them closed; do every step within about 30 seconds.
  2. Put the new key in the pocket inside the center console; keep the two working keys inside the vehicle.
  3. Press the door unlock switch three times, then press and release the brake pedal once.
  4. Press the door lock switch three times, then press and release the brake pedal once; the start button light flashes fast (programming mode, two keys found).
  5. Within one minute press the START/STOP button; the message center confirms the new key.
  6. Take the new key out of the pocket and press unlock on it to leave programming mode.
  7. Test lock / unlock and start the engine with the new key.
Watch out: Maximum four Intelligent Access keys; at four keys the display shows MAX # OF KEYS LEARNED and a tool is needed. Out-of-order steps: wait at least one minute before trying again.

Key with a blade (regular or flip)

One tool lists this key.

  • OBDSTAR Key Master G3
    • Add key
    • All keys lost
    • Remote
    no PIN needed

Key type not stated by the list

One tool lists this key.

  • Launch X-431 IMMO
    • Add key
    • All keys lost
    • Remote

Without a tool

The remote is programmed on the car, without a tool. Up to 4 remotes.

When the key changed

Smart key (push to start)

  • 2011 - 2015This yearChip: ID46315 MHzFCC: M3N5WY8609(US / Canada cars)Push-to-start (Intelligent Access).
  • 2016 - 2018Chip: ID49FCC: M3N-A2C31243300, M3N-A2C94078000902 MHz US fobs; 868 MHz fobs elsewhere: read the label.

Key with a blade (regular or flip)

  • 2007 - 2010Chip: 4D-63Blade: H75(US / Canada cars)40-bit version; remote head key (IKT).

Check coverage first: support depends on the tool's software version and the exact model. A tool that is not shown here may still cover this car.

Frequently asked questions

Which keys fit the Lincoln MKX 2013?

18 listings fit the Lincoln MKX 2013: smart keys, remote keys, transponder keys, key shells, emergency blades and key blanks, in 3-, 4- and 5-button versions. Match the part number or FCC ID printed on your original key with the specifications on each listing.

What frequency does the Lincoln MKX 2013 remote use?

Listings for the Lincoln MKX 2013 come in 315 MHz and 433 MHz: the frequency depends on the market the car was sold in, so check it against your original remote before ordering.

Which transponder chip does the Lincoln MKX 2013 key use?

The listings for this car carry: ID46 (HITAG 2) · ID49 (HITAG Pro) · 4D-63 (40-bit) · 4D-63 (80-bit). Check the chip in each listing's specifications.

Which FCC IDs do Lincoln MKX 2013 remotes carry?

The remotes listed for this car carry FCC ID 0UCD6000022, 2010DJ4009, CWTWB1U793 and M3N5WY8609. Match it with the FCC ID printed on your original remote.

Which blade profile does the Lincoln MKX 2013 key use?

The blades listed for this car: FO38.

Which tools program a Lincoln MKX 2013 key?

The tool makers' coverage lists name OBDSTAR Key Master G3 and Launch X-431 IMMO for this car; 2 of them list all keys lost. Check your tool's latest coverage list before the job.

Can the Lincoln MKX 2013 remote be programmed without a tool?

The remote is programmed on the car, without a tool. Up to 4 remotes.