Skip to content

Lincoln MKZ 2014 Key Fob & Car Keys

Keys that fit the 2014 Lincoln MKZ: smart keys and transponder keys, 5 buttons, FCC ID M3NA2C31243300, ID49 (HITAG Pro) or 4D-63 (80-bit) chip. 11 compatible keys, remotes & shells (genuine and aftermarket) available for the 2014 Lincoln MKZ.

Last updated: 17 November 2026

Key specifications for the Lincoln MKZ 2014

Key types
smart keys, transponder keys, key shells, emergency blades and key blanks
Buttons
5-button
Transponder chip
ID49 (HITAG Pro) · 4D-63 (80-bit) · PCF7939FA
Blade profile
HU101 · FO38
Part numbers
PCF7939FA
Compatible FCC IDs

To pick the right part, match the part number or FCC ID printed on your original remote, or listed in the Lincoln parts catalogue, with the specifications on each listing.

A new smart key or remote has to be programmed to the car with a key programmer, and when every key is lost the programming is still done through the diagnostic port. We ship the key worldwide from the UAE by DHL and FedEx; any automotive locksmith or the dealer can cut and program it.

Programming the Lincoln MKZ 2014 key

Smart key (push to start)

One tool lists this key.

  • OBDSTAR Key Master G3
    • Add key
    • All keys lost
    • Remote
    no PIN needed

Programming steps

Add key - on the car(US / Canada cars)

Needs: two working programmed intelligent access keys inside the car, the new intelligent access key

  1. Close all doors and keep them closed. Switch the ignition off.
  2. Remove the rubber cover in the cupholder and place the first working key in the backup slot at the bottom of the cupholder.
  3. Press the START/STOP button, wait 5 seconds, then press it again.
  4. Remove the key. Within 10 seconds, place the second working key in the backup slot and press the START/STOP button.
  5. Wait 5 seconds, press the START/STOP button again, then remove the key.
  6. Wait 5 seconds, place the new key in the backup slot and press the START/STOP button.
  7. Check that the remote buttons work and the car starts with the new key.
Watch out: With only one working key or none, this method does not work: the key needs a tool. If programming fails, wait 10 seconds and start again.
Add key - on the car(US / Canada cars)

Needs: two working Intelligent Access keys, new Intelligent Access key

  1. Make sure the vehicle is off; lift the rubber mat in the front cup holder to find the backup slot at its bottom.
  2. Put the first working key in the backup slot and press START/STOP; wait five seconds and press START/STOP again.
  3. Remove the key; within 10 seconds put the second working key in the slot and press START/STOP.
  4. Wait five seconds, press START/STOP again and remove the key.
  5. Put the new key in the backup slot and press START/STOP.
  6. Check the remote buttons and that the new key starts the engine; if it failed, wait 10 seconds and repeat from step 2.
Watch out: Maximum four Intelligent Access keys. Do the whole sequence within about 30 seconds; out of order, wait one minute and restart.

Key type not stated by the list

One tool lists this key.

  • Launch X-431 IMMO
    • Remote

Without a tool

The remote is programmed on the car, without a tool. It takes two working keys. Up to 4 remotes.

When the key changed

Smart key (push to start)

  • 2013 - 2020This yearChip: ID49FCC: M3N-A2C31243300, M3N-A2C94078000902 MHz US fobs; 868 MHz fobs elsewhere: read the label.

Key with a blade (regular or flip)

  • 2006 - 2009Chip: 4D-63Blade: H75(US / Canada cars)40-bit version. The 2006 car is the Lincoln Zephyr.
  • 2010 - 2012Chip: 4D-63Blade: H75(US / Canada cars)80-bit on most cars: use an 80-bit key.

Check coverage first: support depends on the tool's software version and the exact model. A tool that is not shown here may still cover this car.

Frequently asked questions

Which keys fit the Lincoln MKZ 2014?

11 listings fit the Lincoln MKZ 2014: smart keys, transponder keys, key shells, emergency blades and key blanks, in 5-button versions. Match the part number or FCC ID printed on your original key with the specifications on each listing.

Which transponder chip does the Lincoln MKZ 2014 key use?

The listings for this car carry: ID49 (HITAG Pro) · 4D-63 (80-bit) · PCF7939FA. Check the chip in each listing's specifications.

Which FCC IDs do Lincoln MKZ 2014 remotes carry?

The remotes listed for this car carry FCC ID M3NA2C31243300. Match it with the FCC ID printed on your original remote.

Which blade profile does the Lincoln MKZ 2014 key use?

The blades listed for this car: HU101 · FO38.

Which tools program a Lincoln MKZ 2014 key?

The tool makers' coverage lists name OBDSTAR Key Master G3 and Launch X-431 IMMO for this car; 1 of them lists all keys lost. Check your tool's latest coverage list before the job.

Can the Lincoln MKZ 2014 remote be programmed without a tool?

The remote is programmed on the car, without a tool. It takes two working keys. Up to 4 remotes.