Mazda Tribute 2010 Key Fob & Car Keys
Keys that fit the 2007–2011 Mazda Tribute: remote keys and transponder keys, 3 buttons, FCC ID CWTWB1U345 or H92PT. 3 compatible keys, remotes & shells (genuine and aftermarket) available for the 2010 Mazda Tribute.
Last updated: 6 November 2026
Key specifications for the Mazda Tribute 2007–2011
- Key types
- remote keys, transponder keys, key shells and emergency blades
- Buttons
- 3-button
- Compatible FCC IDs
To pick the right part, match the part number or FCC ID printed on your original remote, or listed in the Mazda parts catalogue, with the specifications on each listing.
A new smart key or remote has to be programmed to the car with a key programmer, and when every key is lost the programming is still done through the diagnostic port. We ship the key worldwide from the UAE by DHL and FedEx; any automotive locksmith or the dealer can cut and program it.
- $1.40In Stock
- $1.03In Stock
- $1.12In Stock
Programming the Mazda Tribute 2010 key
Key with a blade (regular or flip)
3 tools list this key. 2 of them list all keys lost.
- OBDSTAR Key Master G3
- Add key
- All keys lost
- Remote
no PIN needed - XTOOL X100 PAD3 / X100 MAX
- Add key
- All keys lost
- Add key
All keys lost is listed by OBDSTAR Key Master G3 and XTOOL X100 PAD3 / X100 MAX. Lonsdor K518 lists add key only.
Programming steps
Add key - on the car(US / Canada cars)
Needs: two working keys, new transponder key cut to the vehicle
- Cut the new SecuriLock key (or flip / integrated keyhead key) to the vehicle and keep it next to two keys that already start the engine.
- Put the first working key in the ignition, switch to ON for 3 to 10 seconds, then switch OFF and pull it out.
- Within 10 seconds put the second working key in, switch to ON for 3 to 10 seconds, then OFF and pull it out.
- Within 10 seconds put the new key in and switch to ON; leave it on for at least 6 seconds.
- Check: the theft light comes on for about 3 seconds and goes out, and the new key starts the engine. A flashing theft light means it was not learned.
- For each extra key wait about 20 seconds and start again from step 2.
Key type not stated by the list
One tool lists this key.
- Launch X-431 IMMO
- Remote
Without a tool
The remote is programmed on the car, without a tool. Up to 4 remotes.
Programming steps
Program the remote without a tool(US / Canada cars)
Needs: Procedure A (door lock cycle confirmation), every remote the customer keeps
- Close all doors, open the driver's door, press UNLOCK on the driver's door switch with the door open, and insert the key.
- Cycle the key between OFF and RUN eight times inside 8 seconds, ending on RUN (RUN is the position just before cranking).
- The door locks cycle to show programming mode. If they do not, remove the key and start again from the first step.
- Press any button on the first remote no later than 10 seconds after. The locks cycle to confirm it.
- Within 10 seconds of each confirmation, press any button on the next remote and wait for the locks to cycle. Do this for every remote.
- Turn the key to OFF. The locks cycle once more to end programming mode.
Program the remote without a tool(US / Canada cars)
Needs: Procedure B (chime confirmation), every remote the customer keeps
- Buckle the driver's seat belt and close all doors.
- Cycle the key between OFF and RUN four times inside 3 seconds.
- Turn the key to OFF. A chime confirms programming mode.
- No later than 10 seconds after, hold any button on the first remote until one chime confirms it.
- Again inside 10 seconds, hold any button on the next remote until one chime confirms it. Do this for every remote.
- Turn the key to RUN to leave programming mode.
When the key changed
Key with a blade (regular or flip)
- 2001 - 2004Chip: 4D-60Blade: H75(US / Canada cars)
- 2005 - 2011This yearChip: 4D-63Blade: H75(US / Canada cars)2005 can carry either chip, read the key; integrated remote key from 2008
Check coverage first: support depends on the tool's software version and the exact model. A tool that is not shown here may still cover this car.
Frequently asked questions
Which keys fit the Mazda Tribute 2007–2011?
3 listings fit the Mazda Tribute 2007–2011: remote keys, transponder keys, key shells and emergency blades, in 3-button versions. Match the part number or FCC ID printed on your original key with the specifications on each listing.
Which FCC IDs do Mazda Tribute 2007–2011 remotes carry?
The remotes listed for this car carry FCC ID CWTWB1U345 and H92PT. Match it with the FCC ID printed on your original remote.
Which tools program a Mazda Tribute 2007–2011 key?
The tool makers' coverage lists name OBDSTAR Key Master G3, XTOOL X100 PAD3 / X100 MAX, Lonsdor K518 and Launch X-431 IMMO for this car; 2 of them list all keys lost. Check your tool's latest coverage list before the job.
Can the Mazda Tribute 2007–2011 remote be programmed without a tool?
The remote is programmed on the car, without a tool. Up to 4 remotes.


