Mercury Sable 2010 Key Fob & Car Keys
1 compatible key, remote & shell (genuine and aftermarket) available for the 2010 Mercury Sable.
Last updated: 3 November 2026
Key specifications for the Mercury Sable 2010
- Transponder chip
- 4D-63
To pick the right part, match the part number or FCC ID printed on your original remote, or listed in the Mercury parts catalogue, with the specifications on each listing.
Shells and blades reuse the original electronics, and a blade needs cutting by a locksmith. We ship worldwide from the UAE by DHL and FedEx.
Programming the Mercury Sable 2010 key
Key with a blade (regular or flip)
Programming steps
Add key - on the car(US / Canada cars)
Needs: two original Ford keys that start the car, a new key already cut to the car
- Put the first working key in the ignition, turn to ON (just before cranking) for at least one second, then back to OFF.
- Take it out. Within 10 seconds put the second working key in, turn to ON for at least one second and no more than 10 seconds, then OFF, and take it out.
- Within 20 seconds, put the new key in, turn to ON for at least one second, then back to OFF.
- The security light comes on for 3 seconds: the new key is programmed.
Without a tool
The remote is programmed on the car, without a tool.
Programming steps
Program the remote without a tool(US / Canada cars)
Needs: Procedure A (the owner's manual names the right procedure; otherwise try A, then B), every remote the customer keeps
- Close all doors, open the driver's door, press UNLOCK on the driver's door switch while the door is open, and insert the key.
- Turn the ignition from OFF to RUN 8 times within 8 seconds, ending in RUN (RUN = just before cranking). The locks cycle: programming mode. If they do not, take the key out and start again.
- Within 10 seconds, press any button on the first remote. The locks cycle to confirm.
- Within 10 seconds, press any button on the next remote. The locks cycle again. Repeat for every remote.
- Turn the ignition to OFF. The locks cycle to close programming mode.
- If this fails, run the same procedure with the driver's door closed.
Program the remote without a tool(US / Canada cars)
Needs: Procedure B (a chime confirms each stage), every remote the customer keeps
- Fasten the seat belt and close all doors.
- Turn the ignition from OFF to RUN 4 times within 3 seconds.
- Turn the ignition to OFF. A chime confirms programming mode.
- Within 10 seconds, press and hold any button on the first remote. One chime confirms it.
- Within 10 seconds, press and hold any button on the second remote. One chime confirms it.
- Turn the ignition to RUN to leave programming mode.
When the key changed
Key with a blade (regular or flip)
- 1996 - 1999Chip: 4CBlade: H75(US / Canada cars)Transponder was optional on these years.
- 2000 - 2009Chip: 4D-63Blade: H75(US / Canada cars)40-bit version. No Sable was built for 2006-2007.
Check coverage first: support depends on the tool's software version and the exact model. A tool that is not shown here may still cover this car.
Frequently asked questions
Which transponder chip does the Mercury Sable 2010 key use?
The listings for this car carry: 4D-63. Check the chip in each listing's specifications.
Can the Mercury Sable 2010 remote be programmed without a tool?
The remote is programmed on the car, without a tool.
