Skip to content

Mitsubishi Eclipse 2011 Key Fob & Car Keys

Keys that fit the 2008–2012 Mitsubishi Eclipse: remote keys, 3 buttons, FCC ID 0UCG8D620MA, CN3 cloning chip chip. 5 compatible keys, remotes & shells (genuine and aftermarket) available for the 2011 Mitsubishi Eclipse.

Last updated: 12 November 2026

Key specifications for the Mitsubishi Eclipse 2008–2012

Key types
remote keys, key shells, emergency blades and key blanks
Buttons
3-button
Transponder chip
CN3 cloning chip
Compatible FCC IDs

To pick the right part, match the part number or FCC ID printed on your original remote, or listed in the Mitsubishi parts catalogue, with the specifications on each listing.

A new smart key or remote has to be programmed to the car with a key programmer, and when every key is lost the programming is still done through the diagnostic port. We ship the key worldwide from the UAE by DHL and FedEx; any automotive locksmith or the dealer can cut and program it.

Programming the Mitsubishi Eclipse 2011 key

Key with a blade (regular or flip)

2 tools list this key. 1 of them list all keys lost.

  • OBDSTAR Key Master G3
    • Add key
    • All keys lost
    • Remote
    • Add key

All keys lost is listed by OBDSTAR Key Master G3. Lonsdor K518 lists add key only.

Programming steps

Add key - on the car(US / Canada cars)

Needs: Immobilizer key (except cars sold in Canada), two working registered keys, a new immobilizer key cut to the car

  1. Insert the first working key and turn it to ON for 5 seconds.
  2. Turn it to LOCK and remove it.
  3. Within 30 seconds, insert the second working key and turn it to ON. After about 10 seconds the immobilizer light starts to blink.
  4. When the light blinks, turn the second key to LOCK and remove it.
  5. Within 30 seconds of the light starting to blink, insert the new key and turn it to ON.
  6. The immobilizer light comes on for 3 seconds then goes off: the key is registered. If the light goes off during the procedure, there was an error.
  7. For another key, start again from step 1.
Watch out: Not for cars sold in Canada. With fewer than two working keys, the key needs a tool. Up to 6 keys can be added to the 2 supplied.

Key type not stated by the list

One tool lists this key.

  • Launch X-431 IMMO
    • Add key

Without a tool

The remote is programmed on the car, without a tool. Up to 4 remotes.

Programming steps

Program the remote without a tool(US / Canada cars)

Needs: every remote to be programmed, a jumper wire for the data port

  1. Find the data port.
  2. Insert the key and leave the ignition at OFF.
  3. Check that terminals 1 and 4 have metal pins, then bridge terminals 1 and 4 with a jumper wire. Leave it connected until the end.
  4. Within 10 seconds of connecting the wire, press the hazard switch 6 times. The locks lock and unlock once: programming mode is on.
  5. Press LOCK on the remote 3 times within 10 seconds. The locks lock and unlock once to confirm.
  6. Repeat the LOCK presses on each extra remote within 1 minute, up to 4 remotes including existing ones. The locks lock and unlock once after each.
  7. Disconnect the jumper wire and remove the key.
Watch out: Be sure which terminals are 1 and 4 before bridging them. Up to 4 remotes can be programmed, existing ones included.

When the key changed

Smart key (push to start)

  • 2018 - 2023Chip: ID47(GCC / Europe cars)Eclipse Cross push-start key; match the part number
  • 2018 - 2023Chip: ID47315 MHzFCC: OUCGHR-M013(US / Canada cars)Eclipse Cross push-start key

Key with a blade (regular or flip)

  • 2000 - 2005Chip: 4D-61(US / Canada cars)Plain transponder key; separate keyless remote
  • 2006 - 2012This yearChip: ID46FCC: OUCG8D-620M-AMIT16A key to early 2007, MIT17 key after
  • 2018 - 2023Chip: ID47315 MHzFCC: OUCJ166N(US / Canada cars)Eclipse Cross remote head key (turn-key trims)

Check coverage first: support depends on the tool's software version and the exact model. A tool that is not shown here may still cover this car.

Frequently asked questions

Which keys fit the Mitsubishi Eclipse 2008–2012?

5 listings fit the Mitsubishi Eclipse 2008–2012: remote keys, key shells, emergency blades and key blanks, in 3-button versions. Match the part number or FCC ID printed on your original key with the specifications on each listing.

Which transponder chip does the Mitsubishi Eclipse 2008–2012 key use?

The listings for this car carry: CN3 cloning chip. Check the chip in each listing's specifications.

Which FCC IDs do Mitsubishi Eclipse 2008–2012 remotes carry?

The remotes listed for this car carry FCC ID 0UCG8D620MA. Match it with the FCC ID printed on your original remote.

Which tools program a Mitsubishi Eclipse 2008–2012 key?

The tool makers' coverage lists name OBDSTAR Key Master G3, Lonsdor K518 and Launch X-431 IMMO for this car; 1 of them lists all keys lost. Check your tool's latest coverage list before the job.

Can the Mitsubishi Eclipse 2008–2012 remote be programmed without a tool?

The remote is programmed on the car, without a tool. Up to 4 remotes.