Skip to content

Suzuki Swift 2008 Key Fob & Car Keys

Keys that fit the 2006–2008 Suzuki Swift: remote keys and transponder keys, 2 buttons, 433 MHz. 5 compatible keys, remotes & shells (genuine and aftermarket) available for the 2008 Suzuki Swift.

Last updated: 12 November 2026

Key specifications for the Suzuki Swift 2006–2008

Key types
remote keys, transponder keys, key shells, emergency blades and key blanks
Frequency
433 MHz
Buttons
2-button
Blade profile
HU133
Part numbers
37145-63J60 · 37145-57J10
Battery
CR1620

To pick the right part, match the part number or FCC ID printed on your original remote, or listed in the Suzuki parts catalogue, with the specifications on each listing. Every remote listed for the Suzuki Swift 2006–2008 transmits on 433 MHz.

A new smart key or remote has to be programmed to the car with a key programmer, and when every key is lost the programming is still done through the diagnostic port. We ship the key worldwide from the UAE by DHL and FedEx; any automotive locksmith or the dealer can cut and program it.

Programming the Suzuki Swift 2008 key

Key with a blade (regular or flip)

2 tools list this key. 2 of them list all keys lost.

  • OBDSTAR Key Master G3
    • Add key
    • All keys lost
    • Remote
    reads the PIN by OBD
  • XTOOL X100 PAD3 / X100 MAX
    • All keys lost

Programming steps

All keys lost - XTOOL X100 Pro / Advanced Diagnostics (ADS192)

Needs: new key(s) cut to the lock, PIN: tool reads the immobiliser ID code by OBD and the 4-digit code is calculated from it

  1. Connect by OBD, ignition ON, select Suzuki > Swift immobiliser.
  2. Read the ID code; get the 4-digit security code from it (tool calculation or code service) and enter it.
  3. Erase keys: switch OFF when asked and let the tool clear all stored keys.
  4. Program keys: key in, ignition ON, wait for the tool; then remove, insert the next key and switch ON.
  5. Repeat for each key, then switch OFF and start the engine with every key.
  6. Program the remotes with the on-board routine afterwards.
Watch out: Erase clears every key; have all keys ready. A failed program after erase leaves the car with no keys: check the chip type and the security code before erasing. If the immo lamp flashes after programming, use the tool's reset function.

Key type not stated by the list

One tool lists this key.

  • Launch X-431 IMMO
    • Add key

Without a tool

Programming steps

Program the remote without a tool

Needs: working key or emergency blade in the ignition, every remote / keyless-start fob the customer keeps

  1. Sit in the driver's seat, close all doors, make sure the driver's door is unlocked, insert the key (do not turn).
  2. Within 25 seconds: lock-unlock the driver's door lock 3 times, then lock once more.
  3. Still inside the 25 seconds: pull the key out and push it back in 4 times.
  4. Start the engine and let it run 3 seconds, then switch OFF (leave the key in): the buzzer sounds twice and the locks cycle, registration mode is on.
  5. Within 30 seconds press LOCK or UNLOCK on the remote; the buzzer sounds twice and the locks cycle.
  6. Repeat for each further remote within 30 seconds (up to 4).
  7. Remove the key or turn to ON to leave registration mode; test every remote.
Watch out: Register every remote in the same session. Remote / keyless-entry ID only: if the car will not start with the fob (keyless start), the immobiliser side needs a tool.

When the key changed

Smart key (push to start)

  • 2011 - 2017Chip: ID46433 MHzFCC: TS008(GCC / Europe cars)Keyless start trims
  • 2017 - 2023Chip: ID47433 MHzFCC: 0UCR55R3(GCC / Europe cars)

Key with a blade (regular or flip)

  • 2005 - 2017This yearChip: ID46433 MHz(GCC / Europe cars)

Check coverage first: support depends on the tool's software version and the exact model. A tool that is not shown here may still cover this car.

Frequently asked questions

Which keys fit the Suzuki Swift 2006–2008?

5 listings fit the Suzuki Swift 2006–2008: remote keys, transponder keys, key shells, emergency blades and key blanks, in 2-button versions. Match the part number or FCC ID printed on your original key with the specifications on each listing.

What frequency does the Suzuki Swift 2006–2008 remote use?

Every remote listed for the Suzuki Swift 2006–2008 transmits on 433 MHz.

Which blade profile does the Suzuki Swift 2006–2008 key use?

The blades listed for this car: HU133.

Which tools program a Suzuki Swift 2006–2008 key?

The tool makers' coverage lists name OBDSTAR Key Master G3, XTOOL X100 PAD3 / X100 MAX and Launch X-431 IMMO for this car; 2 of them list all keys lost. Check your tool's latest coverage list before the job.