Skip to content

Cadillac CTS 2011 Key Fob & Car Keys

Keys that fit the 2010–2013 Cadillac CTS: smart keys, remote keys and transponder keys, 4 or 5 buttons, FCC ID M3N5WY7777A, 0UC6000066 or NBG009768T, ID46 (HITAG 2) or NXP PCF7936AA chip, 315 MHz. 10 compatible keys, remotes & shells (genuine and aftermarket) available for the 2011 Cadillac CTS.

Last updated: 15 November 2026

Key specifications for the Cadillac CTS 2010–2013

Key types
smart keys, remote keys, transponder keys, key shells, emergency blades and key blanks
Frequency
315 MHz
Buttons
4- and 5-button
Transponder chip
ID46 (HITAG 2) · NXP PCF7936AA
Part numbers
20998254
Battery
CR2032

To pick the right part, match the part number or FCC ID printed on your original remote, or listed in the Cadillac parts catalogue, with the specifications on each listing. Every remote listed for the Cadillac CTS 2010–2013 transmits on 315 MHz.

A new smart key or remote has to be programmed to the car with a key programmer, and when every key is lost the programming is still done through the diagnostic port. We ship the key worldwide from the UAE by DHL and FedEx; any automotive locksmith or the dealer can cut and program it.

Programming the Cadillac CTS 2011 key

Smart key (push to start)

5 tools list this key. 2 of them list all keys lost.

Programming steps

Add key - on the car(US / Canada cars)

Needs: Smart Key System cars, with one working smart key, one working (recognized) smart key, every new smart key to add

  1. Turn the car off, set the working smart key(s) in the cupholder and keep the new key with you.
  2. Put the key blade in the driver door lock and turn it to UNLOCK five times within 5 seconds. The DIC shows READY TO LEARN ELECTRONIC KEY #2, 3 or 4.
  3. Put the new smart key in the transmitter pocket in the center console between the front seats, buttons facing the front of the car.
  4. A chime means the key is stored. The cluster then reads READY TO LEARN ELECTRONIC KEY #3 or 4, or MAXIMUM # ELECTRONIC KEYS LEARNED.
  5. Press the ignition control knob to leave programming mode.
  6. Take the key out of the pocket and press UNLOCK on it twice.
  7. For each extra smart key, repeat steps 3 to 6.
Watch out: The car must be off. Up to 4 smart keys can be programmed.
Add key - on the car(US / Canada cars)

Needs: Smart Key System cars, no working smart key, every smart key the customer keeps, old and new, about 30 minutes with the car off

  1. Turn the car off and put the new smart key in the transmitter pocket in the center console between the front seats, buttons facing the front of the car.
  2. Put the key blade in the driver door lock and turn it to UNLOCK five times within 5 seconds. The DIC shows READY TO LEARN KEYS.
  3. Push the ignition switch in. The DIC shows LEARN DELAY ACTIVE WAIT XX MIN and counts down to zero.
  4. When the DIC asks again with PRESS START CONTROL TO LEARN KEYS, push the ignition switch in again and wait for the next countdown.
  5. Do step 4 once more (three presses and three 10-minute countdowns in total).
  6. After the last countdown a beep sounds and the DIC shows READY TO LEARN ELECTRONIC KEY # X. Every old key is now erased.
  7. A beep confirms the key in the pocket is learned. The DIC shows READY TO LEARN ELECTRONIC KEY # 2.
  8. For each extra key, put it in the pocket until it beeps and the DIC moves to the next number. At 4 keys the DIC shows MAXIMUM # ELECTRONIC KEYS LEARNED and leaves programming mode.
  9. Press the ignition control knob when you are done.
  10. Press UNLOCK on each newly programmed key to finish.
Watch out: This erases every stored smart key; program all keys the customer keeps. Takes three 10-minute countdowns with the car off. Up to 4 smart keys can be programmed.
Add key - on the car(US / Canada cars)

Needs: one working transmitter, new transmitter (key blade cut)

  1. Have the vehicle off and every transmitter (working and new) with you.
  2. Put the recognized transmitter in the cupholder.
  3. Insert the key blade in the driver door lock and turn to unlock five times within five seconds; the DIC shows it is ready to learn electronic key #2, 3 or 4.
  4. Place the new transmitter in the pocket inside the center console storage, buttons facing forward; a beep confirms it is learned.
  5. Press the ignition control knob to leave programming mode.
  6. Take the transmitter out of the pocket and press unlock on it two times.
  7. Repeat steps 4-6 for each further transmitter.
Watch out: Up to four transmitters (2008-2013 manuals). Canadian cars need two recognized transmitters (owner's manual).
All keys lost - on the car(US / Canada cars)

Needs: every transmitter to be kept, 30 minutes

  1. Have every transmitter the customer keeps with you; cut the key blade if no transmitter works.
  2. With the vehicle off, place a new transmitter in the console pocket, buttons facing forward.
  3. Insert the key blade in the driver door lock and turn to unlock five times within five seconds; the DIC asks you to press the start control.
  4. Press the ignition control knob in; the DIC counts down a 10-minute learn delay.
  5. Each time the DIC asks again, press the knob in; three 10-minute waits in all (about 30 minutes).
  6. After the third wait a beep sounds and the transmitter in the pocket is learned as key #1; every older transmitter is now erased.
  7. Put each further transmitter in the pocket until it beeps and the DIC moves to the next number, then press the knob to finish.
  8. Press unlock on each newly learned transmitter.
Watch out: Every previously learned transmitter is erased. Up to four transmitters. Not available in Canada (owner's manual).

Key with a blade (regular or flip)

3 tools list this key. 2 of them list all keys lost.

  • OBDSTAR Key Master G3
    • Add key
    • All keys lost
    • Remote
    reads the PIN by OBD
    • All keys lost
  • Launch X-431 IMMO
    • Add key

All keys lost is listed by OBDSTAR Key Master G3 and Lonsdor K518. Launch X-431 IMMO lists add key only.

Programming steps

Add key - on the car(US / Canada cars)

Needs: one working key, new key cut to the vehicle

  1. Cut the new key to the vehicle; have one key that already starts it.
  2. Put the working key in the ignition and turn it to ON/RUN (or start the engine), then turn it to LOCK/OFF and remove it.
  3. Within five seconds insert the new key and turn it to ON/RUN.
  4. The security light goes off when the key is learned (this can be too fast to notice).
  5. Start the engine with the new key; for each further key repeat from step 2.
Watch out: Adds only; never erases keys. Up to 10 keys (2008-2013 manuals).

Without a tool

The remote is programmed on the car, without a tool. Up to 4 remotes.

When the key changed

Smart key (push to start)

  • 2008 - 2015This yearChip: ID46315 MHzFCC: M3N5WY7777A(US / Canada cars)Keyless access cars; start with the ignition control knob.
  • 2014 - 2019Chip: ID46Blade: HU100FCC: HYQ2AB, HYQ2EBHYQ2AB is 315 MHz, HYQ2EB is 433 MHz: read the FCC ID.

Key with a blade (regular or flip)

  • 2008 - 2013This yearChip: ID46Blade: B111(US / Canada cars)Key-start cars without keyless access.

Check coverage first: support depends on the tool's software version and the exact model. A tool that is not shown here may still cover this car.

Frequently asked questions

Which keys fit the Cadillac CTS 2010–2013?

10 listings fit the Cadillac CTS 2010–2013: smart keys, remote keys, transponder keys, key shells, emergency blades and key blanks, in 4- and 5-button versions. Match the part number or FCC ID printed on your original key with the specifications on each listing.

What frequency does the Cadillac CTS 2010–2013 remote use?

Every remote listed for the Cadillac CTS 2010–2013 transmits on 315 MHz.

Which transponder chip does the Cadillac CTS 2010–2013 key use?

The listings for this car carry: ID46 (HITAG 2) · NXP PCF7936AA. Check the chip in each listing's specifications.

Which FCC IDs do Cadillac CTS 2010–2013 remotes carry?

The remotes listed for this car carry FCC ID 0UC6000066, M3N5WY7777A and NBG009768T. Match it with the FCC ID printed on your original remote.

Which tools program a Cadillac CTS 2010–2013 key?

The tool makers' coverage lists name OBDSTAR Key Master G3, Lonsdor K518, Autel KM100 (IKEY universal smart key), Xhorse VVDI Key Tool Max, Xhorse VVDI Key Tool Plus and Launch X-431 IMMO for this car; 2 of them list all keys lost. Check your tool's latest coverage list before the job.

Can the Cadillac CTS 2010–2013 remote be programmed without a tool?

The remote is programmed on the car, without a tool. Up to 4 remotes.