Skip to content

Subaru Outback 2008 Key Fob & Car Keys

Keys that fit the 2008 Subaru Outback: remote keys, 3 buttons, 4D-60 chip. 4 compatible keys, remotes & shells (genuine and aftermarket) available for the 2008 Subaru Outback.

Last updated: 12 November 2026

Key specifications for the Subaru Outback 2008

Key types
remote keys, key shells, emergency blades and key blanks
Buttons
3-button
Transponder chip
4D-60
Blade profile
DAT17

To pick the right part, match the part number or FCC ID printed on your original remote, or listed in the Subaru parts catalogue, with the specifications on each listing.

A new smart key or remote has to be programmed to the car with a key programmer, and when every key is lost the programming is still done through the diagnostic port. We ship the key worldwide from the UAE by DHL and FedEx; any automotive locksmith or the dealer can cut and program it.

Programming the Subaru Outback 2008 key

Key type not stated by the list

One tool lists this key.

  • OBDSTAR Key Master G3
    • All keys lost(non-US cars)
    • Remote

Without a tool

The remote is programmed on the car, without a tool. Up to 4 remotes.

Programming steps

Program the remote without a tool(US / Canada cars)

Needs: The 8-digit ID code of each remote (on the package of a new remote, or on the label inside the case), Every remote the customer keeps

  1. Sit in the driver's seat with all doors and the rear gate or trunk closed.
  2. Open and close the driver's door once.
  3. Within 45 seconds, open and close the driver's door once more.
  4. Turn the key from LOCK to ON 10 times within 15 seconds. One tone, then a steady buzzer and a flashing interior light until registration ends. No tone, buzzer or flashing means a missed window: start over.
  5. Within 45 seconds, open and close the driver's door once, within 15 seconds. A tone sounds for 30 seconds. No tone means start again from step 3.
  6. Before the tone stops, push the door lock switch to LOCK as many times as the leftmost code digit (8 presses for an 8), then push it to UNLOCK within 5 seconds.
  7. Enter the remaining 7 digits the same way, pushing to UNLOCK within 5 seconds after each digit.
  8. Within 5 seconds, push to UNLOCK once more, then enter the full 8-digit code a second time, starting from the left.
  9. After the 8th digit of the second entry a tone sounds for 30 seconds: the code is registered.
  10. For another remote, repeat from step 4. When all are done, remove the key and test the remotes.
Watch out: Up to 4 remotes can be stored. If code entry does not start before the tone stops, it is an error: start again from step 3. More than 5 seconds between two presses is an error: restart from step 4, and from step 3 after six errors. If the second code entry differs from the first, restart from step 5, and from step 3 after five errors. A lost remote stays in memory. To clear it, store 4 codes in total: one remote 4 times, two remotes twice each, or three remotes with one of them twice. Make sure nobody uses another keyless remote near the car while programming: its code could be stored in this car.

When the key changed

Smart key (push to start)

  • 2015 - 2017Chip: G315 MHzFCC: HYQ14AHC(US / Canada cars)Push-start trims, key 88835-AL04A
  • 2018 - 2023Chip: 8A433 MHzFCC: HYQ14AHK(US / Canada cars)Subaru H smart key 88835-FL03A, 434 MHz

Key with a blade (regular or flip)

  • 2005 - 2009This yearChip: 4D-62FCC: CWTWBU745US cars: GT / XT trims only in 2005
  • 2015 - 2019Chip: GFCC: CWTWB1U811, CWTB1G077(US / Canada cars)Subaru G (80-bit); CWTB1G077 key on 2018-2019 cars
  • 2020 - 2023Chip: H (8A)433 MHzFCC: CWTB1G077(US / Canada cars)Remote head key 57497-AN00A, turn-key trims

Check coverage first: support depends on the tool's software version and the exact model. A tool that is not shown here may still cover this car.

Frequently asked questions

Which keys fit the Subaru Outback 2008?

4 listings fit the Subaru Outback 2008: remote keys, key shells, emergency blades and key blanks, in 3-button versions. Match the part number or FCC ID printed on your original key with the specifications on each listing.

Which transponder chip does the Subaru Outback 2008 key use?

The listings for this car carry: 4D-60. Check the chip in each listing's specifications.

Which blade profile does the Subaru Outback 2008 key use?

The blades listed for this car: DAT17.

Which tools program a Subaru Outback 2008 key?

The tool makers' coverage lists name OBDSTAR Key Master G3 for this car; 1 of them lists all keys lost. Check your tool's latest coverage list before the job.

Can the Subaru Outback 2008 remote be programmed without a tool?

The remote is programmed on the car, without a tool. Up to 4 remotes.